Home / Lacrosse Gear and Equipment

Lacrosse Stick Tape: How and Why Players Tape a Stick

Lacrosse Stick Tape: How and Why Players Tape a Stick

Photo: Pixabay / Pexels

Why Players Tape a Lacrosse Stick

Tape gives a player grip, feedback, and consistency. A bare metal or composite shaft can feel slippery in rain, cold, or sweat. A taped section tells the hands where they are without looking, which matters when a player slides the top hand for a pass or sets the bottom hand for a shot.

Tape also protects the shaft from small dings and gives the butt end a knob that keeps the stick from sliding through the bottom hand. Most taping is personal preference within the rules, but the basics are the same for beginners and advanced players: use proper athletic or lacrosse tape, keep it smooth, and replace it when it gets slick or torn.

Interactive tool

Tape Job Quality Check

Check off each step as you finish it. Your progress stays on this page.

0 of 8 complete

0% done

What You Need

You need a roll of cloth athletic tape or lacrosse specific grip tape, scissors, and the stick with its butt end cap in place. Work on a clean, dry shaft. Old tape should be removed fully and any sticky residue wiped off, because new tape over lumpy residue will feel uneven and peel early.

Some players prefer a preformed grip or a textured shaft coating instead of tape. Those are fine options, but tape remains the most adjustable choice because you can add or remove it in minutes to change thickness and placement.

Taping the Butt End Step by Step

The butt end is the most important taping job for a beginner. Start by confirming the plastic or rubber butt end cap is secure on the bottom of the shaft. Tape is not a substitute for a missing cap, and officials can remove a stick with an exposed sharp shaft end.

Wrap tape around the shaft just above the cap several times to build a small knob. The knob should be thick enough that the bottom hand feels a clear stop, but not so large that it feels clumsy. Smooth each wrap so there are no ridges that will blister the palm.

From the knob, continue wrapping upward for a short section where the bottom hand usually rests. Overlap each turn by about half the tape width and keep steady tension. Tear or cut the tape cleanly and press the end down firmly, then roll the taped section between your palms to seat it.

Grip Patterns for the Shaft

The simplest pattern is a short grip: tape only at the butt end section and a small ring or short section where the top hand rests during cradling. This keeps weight low and lets the hands slide freely between positions. Many beginners do best with this setup.

A full grip covers most of the shaft. It maximizes hold in wet weather but can slow hand sliding and add friction that wears gloves. It suits players who rarely slide their hands or who play in consistently wet conditions.

A candy cane or spiral pattern wraps the shaft with spaced diagonal turns, leaving gaps of bare shaft between tape. It offers grip points with less weight and easier sliding than a full grip. A crisscross pattern adds a second spiral in the opposite direction for even more texture. Try one pattern for several practices before judging it. Hands need time to learn a new feel.

Tape rings are another useful tool. A single thin ring of tape at a specific shaft position acts as a tactile marker. A player can use it to find the correct hand placement for shooting or for a faceoff grip without looking down.

The Top Hand Area and the Head

Use tape sparingly near the top of the shaft. A short section where the top hand holds during cradling can help, but thick tape right below the head can interfere with hand movement and with how the head sits on the shaft. Keep the throat and screw area clean and accessible so the head can be tightened or removed when needed.

Be careful about tape and the shooting string area. Shooting strings are part of the pocket inside the head, not the shaft, and they are governed by pocket legality rules. Tape must never be used to alter the pocket, to hold a broken string in place for a game, or to change how the ball releases. If a string breaks, restring or repair the pocket properly and have its legality checked. Tape on the shaft is for grip. Stringing in the head is for ball control, and the two jobs should stay separate.

Rules and Common Sense Limits

Keep tape on the shaft and butt end, keep the butt end cap in place and covered safely, and keep the stick otherwise legal for your level. If tape builds up so thick that it changes the stick into something an official questions, remove it and start simpler. When in doubt at a tournament, ask an official or coach before the game rather than during it.

Faceoff players in the mens game follow one extra tape rule. The shaft must carry a strip of tape in a color that contrasts with the head, the shaft, and the gloves, placed just below the throat without touching the head and running about 6 inches down the shaft. Officials use that band to judge hand position at the faceoff. On every stick, tape belongs on the shaft only and must stay off the head itself.

Tape color is usually a matter of team preference. Some teams ask players to match tape color for uniformity. That is a team rule, not a performance issue.

Replacing and Maintaining Tape

Replace tape when it feels smooth and slick, when edges peel and catch on gloves, or when it becomes soaked and heavy after repeated wet games. Fresh tape before an important tournament is a small ritual many players enjoy, but do not change your grip pattern on game day. Keep the pattern you practiced with.

Remove old tape fully at replacement time and check the shaft underneath for damage. A quick, consistent taping routine gives a player one less thing to think about, and reliable hand feel is a quiet advantage on every catch, pass, and shot.

Tape Placement by Position

Position changes what the hands do, so it changes where tape earns its place. Attack players slide the top hand constantly as they dodge and shoot, so most prefer the short grip: a firm butt end knob, one thin marker ring at the shooting hand position, and bare shaft between. Midfielders who face off need the contrasting band described in the rules section, placed just below the throat, plus a knob they can find without looking during the clamp. Defenders with long poles tape a longer lower section, because the bottom hand stays planted during poke checks and the extra hold helps in wet weather. Goalies tape the lower third more heavily than field players, since the bottom hand anchors every save step and the stick takes ball impacts that twist it in the hands.

None of these are rules. They are conventions collected from how each job uses the shaft, and a player should test a convention for several practices before adopting it as a permanent setup.

How Much Tape Is Too Much

Tape adds weight at the far end from the head, and weight at the butt end changes balance less than weight at the head, but it still adds up. A full shaft wrap on a long pole can add noticeable grams and a spongy feel that dulls the feedback of a poke check. The practical test is the one hand lift: hold the finished stick just below the head with one hand and raise and lower the head slowly ten times. If the wrist tires or the head wobbles, the setup is too heavy somewhere, and tape is the easiest weight to remove. Start light, add tape only where a hand actually slips, and stop the moment both hands feel located without thinking.

A Five Minute Retaping Routine

  1. Strip the old tape in one session rather than layering over it, and wipe the shaft with a damp cloth to clear residue.
  2. Rebuild the butt end knob first, four to six tight wraps just above the cap, and test the bottom hand stop with a glove on.
  3. Add the working sections next: the bottom hand grip length, then any marker rings, checking each position against where the hands actually land during a cradle.
  4. Roll the whole taped area hard between the palms to seat edges, then trim any lifted end and press it flat.
  5. Finish with ten cradles and five passes against a wall. Tape that feels right standing still but shifts during a pass needs one more seating roll, not another layer.

Tape in Wet and Cold Weather

Rain exposes weak taping. Cloth tape absorbs water, gains weight, and turns slick when fully soaked, which is why players in wet climates often choose the spiral pattern: less tape surface holds less water, and the bare shaft gaps drain. In cold weather the problem flips; bare metal numbs fingers through thin gloves, and a fuller wrap insulates the hands. Many players keep one pattern for the spring season and accept the trade either way, but tournament players who travel between climates sometimes run a spiral in summer and a fuller grip in the fall. Changing patterns between seasons is normal. Changing patterns on game day is not, because the hands need a week to learn a new map of the shaft.

Tape Jobs Around the World of the Team Bag

A team level habit worth copying is the shared tape standard. Many programs ask every player to carry one personal roll in the bag, because tape needs appear at the worst times: a knob that flattens during warmups, a marker ring that peels in rain, a butt cap that needs one securing wrap before an official will pass the stick. The roll lives in the small pocket with the mouthguard backup, the two items that rescue game days most often. Captains on organized teams often run a two minute tape check during warmups for younger players, confirming caps are seated and knobs are firm. It looks like a small ritual. It prevents the specific equipment failure that removes a stick from a game, which makes it one of the cheapest insurance habits in the sport.

Frequently Asked Questions

What kind of tape should I buy for a lacrosse stick?

Buy cloth athletic tape or tape sold specifically for lacrosse and hockey grips, in a width that wraps smoothly on a shaft, usually around 1 to 1.5 inches. Avoid electrical tape and duct tape: both leave heavy residue, turn slippery when warm, and can damage shaft finishes when removed.

How often should tape be replaced?

Replace it when the surface feels smooth and slick, when edges lift and catch on gloves, or after it has been soaked repeatedly and stays heavy. For a player practicing three times a week, that often means a fresh tape job every few weeks during the season and always a fresh inspection before playoffs or a tournament.

Can tape make a stick illegal?

Tape on the shaft and butt end is legal in normal use, and the butt end cap must stay in place under it. Problems start when tape is used to change the pocket, to hold a broken head or string together for a game, or when buildup becomes so extreme that an official judges the stick altered. Keep tape in its grip role and the stick stays legal.

Where should a beginner tape first?

Start with the butt end knob and a short bottom hand section only. That single job prevents the most common beginner problem, the stick sliding through the bottom hand during a cradle, without adding weight or slowing hand movement. Add a top hand marker ring later, once the player knows where the top hand belongs for a shot.

Does tape color matter in a game?

For most players, color is a team preference. The one functional exception is the faceoff band in the mens game: a strip in a color that contrasts with the head, shaft, and gloves, placed just below the throat, so officials can judge hand position at the faceoff. A faceoff player should treat that band as required equipment, not decoration.